AUTONET TV

3 Winter Windshield Tips (Care of Windshield)

Cold weather can present some real challenges when it comes to your vehicle's windshield.  Think of it.  Your windshield is your window to the world when you're driving, and clear visibility is extraordinarily important for safe travels. So here are 3 tips to ensure that your windshield can do its job during the cold weather.

1. Don't ever pour hot water on a frozen windshield.  Let's say you head outside and see your vehicle covered with ice. You think, hey, maybe I can heat up a pot of water on the stove and melt that off fast.  Don't do it!  You run the risk of shattering the glass the second that hot water hits the frigid glass.  Ditto for using a propane torch.  Glass does not do well with sudden temperature changes.  Instead, turn on your engine and start the defroster, which heats the windshield up gradually.  Use a plastic scraper designed for windshields (don't EVER use metal to scrape) and be patient.  Don't hammer on the ice to break it into pieces.  Sudden pressure and glass don't mix.
2. Keep your wiper blades up off the glass.  If you park your vehicle outside and you think there's a chance of frozen precipitation falling, do what smart winter drivers do.  Lift the wiper arms off the glass and leave them extended with the blades not touching the glass at all.  That way when you go back to your vehicle, you won't have to try to pull the wipers off the icy glass (which can damage the rubber blades) or start the wipers with them frozen solid to the windshield.  Many drivers have burned out their wiper motor that way, and that can be a pricey repair.
3. Keep your windshield washer fluid topped off and use it often.  So you've followed the steps above and you're on the road. Salt, brine and sand can muck up the windshield fast, causing your wiper blades to smear the glass, re-freeze the icy snow and blind you.  It's important to use wiper fluid made for low temperatures so it doesn't freeze on your glass.  Use it often so any road debris won't scratch the glass like sandpaper.  And make sure your defroster is working properly, keeping your windshield warm enough to prevent ice from forming.  

Hill's Auto Repair, Inc.
22829 colton point rd
Bushwood, Maryland 20618
301-769-2400

Low Power Mystery (Ignition Coil Service)

It's no fun when your vehicle just doesn't run the way it used to.   You may notice (especially in cold weather) the engine won't start easily or when it does start, it doesn't run smoothly. It may not have much power at all. You also may have had to stop at the gas station more often, a sign your fuel economy isn't what it used to be. 

There could be a few different things that cause those symptoms, but one culprit could be a bad ignition coil. The coil takes the voltage from your battery and multiplies it before that power is sent over to a spark plug. That allows the plug to fire off a good jolt of electricity that ignites the fuel in your cylinder and powers the engine. 

There's usually one ignition coil for each cylinder (or sometimes for a pair of cylinders). If only one of them is not pushing out enough electricity, it can cause big trouble with your engine performance.  Other signs of a bad ignition coil include engine backfire, an oil leak and your Check Engine light coming on.   When that light comes on and you have some of those other signs, you need to have your repair facility check things out fairly soon because you may be damaging your engine and wind up with a far more expensive repair.

A technician will check for a computer code to pinpoint which cylinder is having the problem.  Using other diagnostics, the technician can rule out other components that might be causing the engine to misfire.  Ignition coils usually last 100,000 miles/160,000 km, but other engine conditions can cause them to fail before then. 

Your service advisor may suggest getting all your coils replaced even though only one is malfunctioning. That's probably a good idea in a higher mileage vehicle since the other coils may be close to failure, too. It's also wise to do that if your vehicle's coils are located in a hard-to-reach spot so you likely won't have to spend the money for that labor again when another one fails.

Hill's Auto Repair, Inc.
22829 colton point rd
Bushwood, Maryland 20618
301-769-2400

Visibility Disaster! (Windshield Washer Pump Replacement)

Let's say you live in a cold climate where the snowy, icy weather challenges you to clear the salt and debris tossed up on your windshield.  You push your windshield washer switch expecting a good stream of fluid so the blades can wipe the glass clean. Yet nothing comes out.  Nada, zip.  What's going on? You know you filled up the windshield washer reservoir within the last week or so. 

Well, there could be a few things causing your windshield washing system to fail.  One culprit? The hoses that are supposed to carry that fluid from the washer pump to the spray nozzles may be frozen, or maybe they're cracked and leaking. It could be the nozzles themselves are stopped up, either iced up or jammed full of debris.  Your windshield wiper/washer switch could be worn out or the electrical system may not be conducting power to the washer pump. 

It's important that this system work properly, especially on days when the sun may be in front of you and your windshield is covered with a cloudy, icy mess.  Seeing what's going on in front of you may be like trying to peer through frosted glass, and that's not a safe situation for you or the drivers around you. You need to have this checked out by a technician as soon as you can.

Let's say the technician discovers it's not any of those components.  Turns out it's the electric windshield washer pump itself that's failed. After replacing it, everything is working fine, and you can see again.  As so often is the case with today's complex vehicles, figuring out the root cause of a problem can be tricky.  Rely on your vehicle service facility since they have the know how and diagnostic equipment to make sure your view of the road will always be crystal clear.

Hill's Auto Repair, Inc.
22829 colton point rd
Bushwood, Maryland 20618
301-769-2400

Clean Slate (Protecting Vehicle's Finish)

Winter is one of the hardest times to keep your vehicle clean. But did you know neglecting to wash your vehicle in winter could cost you a significant amount of money in the long run? Here's why.

Many areas deal with snow and ice in the winter, and the salt and sand that are used to keep the road surfaces from being slick are also super corrosive to a vehicle's metal body and undercarriage.  That includes all the parts underneath that can be splashed with brine, saltwater and other road debris.  Winter is also tough on vehicles where there isn’t snow, sometimes from ocean salt or winter's extra humidity and rain. 

If you have any breaks in your vehicle's paint, whether it be from a little fender bender or a stone chip, that corrosive winter moisture can get through those cracks and start eating away at the metal underneath. 

If you can, you should get any dents or damage fixed as soon as possible so your vehicle has a protective layer of paint between road chemicals and the metal.  You may want to wait until the warmer weather, but while you're waiting, the damage is getting worse.  If you're not sure of a reputable body repair shop, check with the service advisor where you have mechanical work done.  They're usually knowledgeable about who is good and not so good. 

You also may be tempted to skip the car wash during the winter since your vehicle is just going to get dirty fast anyway.  You may want to reconsider.  Many winter road treatments now use brine that gets in every nook and cranny of your vehicle.  It's wise to clean that off regularly during the winter, and many washing facilities include a spray underneath that gets rid of that salt.  Your vehicle repair facility may even have its own car wash, a nice bonus when you take your vehicle in for repair or regular maintenance. 

Hill's Auto Repair, Inc.
22829 colton point rd
Bushwood, Maryland 20618
301-769-2400